CONF PAT

          CONF PAT

Now configure to ROUTER 0 as given below


Router>enable
Router#configure terminal Enter configuration
commands, one per line. End with CNTL/Z.
Router(config)#hostname R1
R1(config)#interface fastEthernet 0/0
R1(config-if)#ip address 192.168.0.1 255.255.255.0
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#interface serial 0/0/0
R1(config-if)#ip address 30.0.0.1 255.0.0.0
R1(config-if)#clock rate 64000
R1(config-if)#bandwidth 64
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#ip route 0.0.0.0 0.0.0.0 serial 0/0/0
R1(config)#access-list 1 permit 192.168.0.0
0.0.0.255
R1(config)#ip nat pool test 50.0.0.1 50.0.0.1
netmask 255.0.0.0
R1(config)#ip nat inside source list 1 pool test
overload
R1(config)#interface fastEthernet 0/0
R1(config-if)#ip nat inside
R1(config-if)#exit
R1(config)#interface serial 0/0/0
R1(config-if)#ip nat outside
R1(config-if)#exit
R1(config)# Router(config)#interface serial 0/0/0
 Router(config-if)#no shutdown


Now configure to ROUTER 1 as given below


Router>enable
Router#configure terminal                              
  Router(config)#interface serial 0/            Router(config-if)#ip address 30.0.0.2 255.0.0.0                    Router(config-if)#no shutdown                                       Router(config-if)#exit
Router(config)#interface fastEthernet 0/0
Router(config-if)#ip address 20.0.0.1 255.0.0.0
Router(config-if)#no shutdown
Router(config-if)#exit
Router(config)#hostname R2
R2(config)#ip route 0.0.0.0 0.0.0.0 serial 0/0/0


Now go on pc and ping to 20.0.0.2