DYNAMIC NAT- CICSO ROUTER CONF

DYNAMIC NAT

IN ROUTER 0

Router>enable
Router#configure terminal
Router(config)#hostname R1
R1(config)#interface fastethernet 0/0
R1(config-if)#ip address 192.168.0.1 255.0.0.0
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#interface serial 0/0/0
R1(config-if)#ip address 30.0.0.1 255.0.0.0
R1(config-if)#clock rate 64000
R1(config-if)#bandwidth 64
R1(config-if)#no shutdown
R1(config-if)#exit
R1(config)#ip route 0.0.0.0 0.0.0.0 serial 0/0/0
R1(config)#access-list 1 permit 192.168.0.0 0.0.0.255
R1(config)#ip nat pool test 50.0.0.1 50.0.0.5
netmask 255.0.0.0
R1(config)#ip nat inside source list 1 pool test
R1(config)#interface fastEthernet 0/0
R1(config-if)#ip nat inside
R1(config-if)#exit
R1(config)#interface serial 0/0/0
R1(config-if)#ip nat outside
R1(config-if)#exit
R1(config)#exit

In Router 1

Router>enable
Router#configure terminal
Router(config)#interface fastEthernet 0/0
Router(config-if)#ip address 20.0.0.1 255.0.0.0
Router(config-if)#no shutdown
Router(config-if)#exit
Router(config)#interface serial 0/0/0
Router(config-if)#ip address 30.0.0.2 255.0.0.0
Router(config-if)#no shutdown
Router(config-if)#exit
Router(config)#ip route 0.0.0.0 0.0.0.0 serial 0/0/0
Router(config)#hostname R2

        For testing of NAT go R1 and enable debug for NAT from privilege mode

  R1#debug ip nat

Now go on pc and ping to 20.0.0.2                                                                                  FaZfAj!®